M2/M3 BFV: HULL POWER DIST SYSTEM - OD1606 - LESSON 2/TASK 1
LESSON 2
TROUBLESHOOTING THE M2/M3 BRADLEY FIGHTING
VEHICLE (BFV) HULL POWER DISTRIBUTION SYSTEM
TASK 1.
Describe the general troubleshooting procedures for the
Bradley fighting vehicle (BFV) hull power distribution
system, including the use of special test equipment and the
procedures for hooking up the simplified test equipment-
M1/fighting vehicle system (STE-M1/FVS) vehicle test meter
(VTM only).
CONDITIONS
Within a self-study environment and given the subcourse text, without
assistance.
STANDARDS
Within one hour
REFERENCES
No supplementary references are needed for this task.
1.
Introduction
In lesson 1 of this subcourse, an introduction to the components that
comprise the hull power, distribution system was presented.
Also,
the procedures employed by maintenance personnel to replace these
components were discussed.
In this task, the general procedures used by maintenance personnel to
troubleshoot the hull power distribution system will be presented.
This discussion includes the procedures for using the simplified test
equipment/M1 fighting vehicle system (STE-M1/FVS) vehicle test meter
(VTM) which is used by maintenance personnel when troubleshooting
this system.
39
Previous Page
