M2/M3 BFV: HULL POWER DIST SYSTEM - OD1606 - LESSON 1/PE 1
Tighten the coupling using electrical
To remove the instrument panel volts gage, first, remove the
lamp socket from the back of the gage.
Next remove the nut, lock
washer, and lead 1W10-M1- from the negative terminal of the gage. Be
sure to tag the lead as soon as it is removed. After lead 1W10-M1-
has been removed from the gage, remove the nut, look washer, and lead
1W10+ from the positive terminal of the gage. Again be sure to tag
the lead as soon as it is removed.
Then, remove the two nuts from
the two posts on the gage. Push the volt gage from the two brackets
and out the front of the instrument panel.