(1) There is a self-locking nut on the solenoid shaft. It is removed
with a 1/2-inch socket, hollow shaft driver, and a 5/32-inch Allen wrench.
(2) Slide the socket over the nut and the hollow shaft into the socket;
then insert the Allen wrench into the solenoid shaft (fig 10). To remove the nut,
the socket is turned with an open end wrench while the Allen wrench is held
stationary.
Figure 10.
Removing or installing self-locking nut from solenoid relay
shaft.
mounting bolts are disassembled (fig 11).
c. The shift lever yoke, controlling the drive assembly, is held in place
by the yoke cover. The fillister-head screws (fig 12) are now removed to free the
yoke cover from the intermediate housing.
(1) By lifting the yoke cover slightly, the yoke pin holding the shift
lever yoke is exposed. Using a suitable drift punch, tap the yoke pin from the
yoke cover (fig 13) and free the cover from the housing.
(2) The drive assembly and shift lever yoke may be removed from the
intermediate housing and armature shaft by pulling on the drive assembly (fig 14).
OS O10, 6-P12
Previous Page
