move the module (1) away from the maintenance stand (2), set it on
six wood blocks (7), and remove the gasket (8) from the rear of the
module (9) (fig. 1-61).
Remove the Slings From the Module. Lower the hoist hook (3) until
the transfer sling (10) has slack. Then you can remove the pin (11)
from the shackle (12), the shackle from the block (13), and install
the pin in the shackle. At the other end of the module, remove the
sling hook (14) from the pin (15). Remove the elbow (16), tube tee
(17), and seal (18) from the forward module (fig. 1-61).
Figure 1-61.
Removing the Module from the Maintenance Stand.
You have now removed the forward engine module.
This concludes the lesson. The next item you perform is a Practice Exercise
to prepare you for the examination of this lesson.
50
OD1707
Previous Page
