M2/M3 BFV: FIRE CONTROL SYSTEM - OD1608 - LESSON 2/TASK 1
4.
Hooking Up the STE to the Vehicle
The STE-M1/FVS test set can be hooked up to the Bradley fighting
vehicle in either of two locations, depending on the test to be
performed.
a. Hooking Up the STE. Some tests require that the STE be hooked
up to the vehicle distribution box; others require hookup to the
diagnostic panel. The hookup procedures are similar.
(1) First, the test equipment must be removed from the transit
cases. The VTM, SETCOM, and cable W1 are removed from their transit
case. The CIB, cable CX306, and CX1203 are each removed from their
respective transit cases.
Then, the test equipment is moved to the
vehicle.
(2) Pull the VTM circuit breaker (figure 49) to OFF.
FIGURE 49.
THE VTM CIRCUIT BREAKER.
66
Previous Page
