M2/M3 BFV: FIRE CONTROL SYSTEM - OD1608 - LESSON 2/TASK 1
FIGURE 51.
INTERCONNECTING THE STE COMPONENTS.
(b) To connect the STE to the diagnostic panel, first remove
the center turret floor plate (TM 9-2350-252-20-2-2, page 4-22).
Move the test equipment to the turret. Then remove the cap from jack
J1 on the diagnostic panel (figure 53 on the following page).
Install plug CX306P1 on jack J1 of the diagnostic panel.
Turn the
MASTER POWER switch (figure 54 on page 70) to ON. Then set the CIB
(8) With the STE properly hooked up to the vehicle, the self-
test can be performed.
68