ACA Diode CR1 removal/replacement.

Troubleshooting ther AN/ GVS-5 Laser Observation Devise Test Set, TS-3620
Page Navigation
58

the cathode end (with bar on diode body) was joined to

terminal E2.



Replacement.

Wrap the diode CR1 wire cathode end (bar) to terminal E2,

and the anode end (plain) wire to terminal E3.

Use a heatsink and solder connect the diode to the

terminals.

At terminals E2 and E3, apply from 0.02 to 0.08 inch

thickness of staking compound on all the conductors

joined.

Apply sealing compound to the three screws (7).

Put on the cable support cover (6) and secure with the

three screws.

3-44. ACA Terminal E1 removal/replacement.



Removal.

Remove the four screws (29) and the cover (28).

Desolder and remove the capacitor C1 (27) wire from the

terminal (26).

Unscrew and remove the terminal.



Replacement.

Screw in the terminal E1.

Wrap the capacitor C1 wire onto the terminal. Solder the

wire to the terminal.

Apply sealing compound to the four screws (29).

Put on the cover and secure with the four screws.

3-45. ACA Capacitor C1 removal/replacement.



Removal.

OD1716

Index