4.
You have established the standard initial test conditions. You
have operated the tank and it will not pivot; which of the
following must be your next action?
A.
Get the STE test set.
B.
Notify support maintenance.
C.
Perform a connector inspection.
D.
Check the final drives to ensure they are connected.
5.
You have verified that the final drives are connected properly;
which of the following must be your next action?
A.
Get the STE test set.
B.
Notify support maintenance.
C.
Perform a connector inspection.
D.
Check the road wheels to ensure they are connected.
6.
You have properly installed the STE and run test 1100
(transmission shift). The display on the SETCOM shows a general
instruction message.
Which of the following must be your next
action?
A.
Press the GO key.
B.
Refer to the cable index.
C.
Re-enter test number 1100.
D.
Do the general instruction.
Special Situation:
Use this situation to respond to items 7 through 10.
You must troubleshoot an M1A1 Abrams tank X-1100-3B transmission that
will not move in forward or reverse ranges. Your unit does not have
the STE test set; therefore, you must troubleshoot using the
alternate troubleshooting procedure (appendix E).
38
OD1711
Previous Page
