Item
Correct Answer and Feedback
5.
B.
Notify support maintenance.
If you follow the YES flow line out of block 66, it leads
to block 67 where you find the powerpack has a fault and
you must notify support maintenance. (appendix B)
6.
D.
Do the general instruction.
Follow the YES flow line out of block 23 to block 25.
Block 25 tells you to perform the general instruction, go
back to block 22, and press the GO key on the SETCOM to
resume the test. (appendix B)
7.
B.
Connect a jumper between 4 and 6 on the breakout box
and test for continuity between contacts A and C on
2W104-P7.
Because the multimeter indicates continuity, you must
follow the YES flow line out of block 5 to block 7.
The
first action required in block 7 is to install a jumper
between 4 and 6, and then you must test for continuity
between test points A and C. (appendix E)
8.
B.
Replace the shift control assembly.
Follow the YES flow line out of block 7 to block 9. Block
9 tells you to connect 2W105-9/P1 on the hull networks box,
replace the shift control assembly, and verify you have
solved the problem. (appendix E)
9.
C.
Test for voltage between 1 and 7 on the breakout box.
Since the correct voltage (18 to 30 V
dc) was present, you
must follow the YES flow line out of
block 4 to block 6,
which directs you to block 15. Block
15 tells you to test
for voltage between 1 (-) and 7 (+)
on the breakout box.
(appendix E)
10.
A.
Notify support maintenance.
Follow the YES flow line out of block 16 to block 18. This
block tells you the transmission has a fault and you must
notify support maintenance. (appendix E)
41
OD1711
Previous Page
