465
CORRECT. To assure the accuracy of the monitors they are compared
with certified standards.
467
Para 7a and fig 13
468
Para 7f
470
CORRECT. Rotating the control clockwise increases the charging
potential applied to the batteries.
471
CORRECT. The power service entrance is located at the lower left
front of the test stand.
472
Para 1a
474
CORRECT. The shifter lever is a part of the over-running clutch
476
Fig 15
477
CORRECT.
The Jumper wires complete the field circuit in the rotor.
479
Take another look at figure 7.
480
CORRECT. To prevent body injury, the yoke shifting lever is blocked
in the operating position during STALL TORQUE tests.
482
CORRECT. The relay lamp switch. is a three-position toggle switch
selects the proper circuit for the relay closure indicator lamp.
483
CORRECT.
E = IR = 2 amperes x 6 ohms = 12 volts.
484
Para 2g
485
Para 5
486
Para 4b
488
around it and will cause a force on the wire if the wire itself is in
490
Para 3c
491
Consult figure 22 to determine the effects of temperature on specific
gravity.
492
Para 4a
493
Para 3c
496
CORRECT. This circuit looks very compact on the electrical wiring
diagram, but remember the meter and generator are widely separated
on the test stand.
497
Para 6d(5)
498
CORRECT. The mounting flange adapter connects between the pivot
499
Para 4a
500
Para 3b
11