Figure 1-30. Tube Assemblies ( Forward Reduction Garbox Scavenge ).

Removal of the Accessory Gearbox and Forward Engine Module of the AGT
Page Navigation
24

Gearbox Scavenge).



Remove the Tube Assembly (Oil Pump Return to Oil Cooler - Forward).

Unscrew the tube nut (3) from the nipple (4); at the other end of

the tube assembly, unscrew the tube nut (6) from the nipple (7) and

remove the flared conical seal (5) (fig. 1-31).

NOTE:

Cut off any tie-down straps, as needed, to remove the tube assembly.

Remove the tube assembly (1) for the oil pump (8) and the filter

element (2) from the nipple (7) (fig. 1-31).



Remove the Tube Assembly (Electromechanical Fuel System to the

Bottom of the Inlet Guide Vane Actuating Cylinder). To remove this

tube assembly, you remove the self-locking nut (2) and screw (3)

from the loop clamp (4), and remove the clamp from the tube (1).

Then disconnect the tube nut (5) from the tube (6), and remove the

flared conical seal (7) (fig. 1-32).

Disconnect the tube nut (8) from the adapter

(9), remove the flared

conical seal (10), and move the tube (11) to

the side. Then, using

a 11/16-inch crowfoot wrench, disconnect the

tube nut (12) from the

adapter (13) and remove the tube assembly (1)

and the flared conical

seal (14) (fig. 1-32).

OD1707

Index