M2/M3 BFV: TROUBLESHOOTING - OD1610 - LESSON 1/TASK 2
(4) Blocks 4a through 4d - Miles, Hours, Rounds Fired, Hot Starts.
Enter the meter reading in miles or kilometers as of the date to be inserted
in block 5. Place an M before a reading in miles, or a K before a reading
in kilometers. Leave block 4a blank if miles or kilometers do not apply to
the equipment, or if the equipment has no odometer. Also, leave block 4a
blank if the DA Form 2404 covers more than one item.
In block 4b, enter the meter reading in hours as of the date in block 5.
Leave this block blank if hours do not apply to the equipment, if the
equipment has no hourmeter, or if the DA Form 2404 covers more than one
item.
In block 4c, enter the rounds fired, as of the date in block 5. Leave this
blank if rounds fired do not apply to the equipment, or if the DA Form 2404
covers more than one item.
Block 4d, "Hot Starts," is left blank.
(5) Block 5 - Date.
The current calendar date is entered in block 5.
(6) Block 6 - Type Inspection.
Enter the type of inspection or
service to be performed (lubrication, monthly, quarterly, semiannual, etc.).
When performing more than one inspection or service at the same time, put
the service symbols in block 6 (L/S, etc.).
(7) Blocks 7 - TM Number, TM Date. Enter the number and date of the
equipment TM. When two TMs cover an item, put the second TM number and date
in the second number and date block.
When the manual has changes, print
"W/C" and the latest change number after the TM number--but show the date of
the basic manual.
(8) Blocks 8a and 8b - Signature and Time.
When the inspection or
service is done, the person doing the job signs block 8a.
The entry is
first name, middle initial, last name, rank. Block 8b is left blank, unless
needed locally.
(9) Blocks 9a and 9b - Signature and Time. This signature block is
left blank, unless needed locally.
The time block is also left blank,
unless
38
Previous Page
