M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 1/TASK 2
NOTE
Notch in the center of the separator must align with mating
tab in the body of the AP ammo box.
Turn the separator and ammo belt upside down and insert into the AP ammo box with
the notch and tab aligned. Close and latch the AP ammo box lid.
Step 17.
Stow second 15 rounds of ammo in the AP ammo box. Unlatch and open the
second AP ammo box lid. Remove the separator from the AP ammo box. Repeat second
paragraph of step 16 above to load second 15 rounds.
Step 18.
Install the AP ammo can door by placing the AP ammo can door on the AP
ammo can.
Turn the handle to the left.
Step 19.
Stow the AP ammo.
These procedures, when needed, can be found in TM 9-
2350-252-10-1.
Step 20.
Close the turret shield door.
These procedures, when needed, can be
found on page 2-139 of TM 9-2350-252-10-2.
WARNING
If the turret is entered with turret power on, the soldier
may be injured or killed.
Do not enter the turret while
turret power is on. Keep the turret shield door closed and
latched while turret power is on.
Step 21.
Move the TURRET POWER switch to ON.
Step 22.
Move the TURRET DRIVE SYSTEM switch to ON.
Step 23.
Release the turret travel lock.
These procedures, when needed, can be
found on page 2-141 of TM 9-2350-252-10-2.
Step 24.
Traverse the turret to 6400 mils.
These procedures, when needed, can
be found on page 2-152 of TM 9-2350-252-10-2.
63
Previous Page
