M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 3/TASK 1
FIGURE 22.
TESTING CIB CABLE CX304.
CAUTION
Be careful when connecting plug TA301 to cable CX304.
The
connector pins are easily bent or broken.
Step 2.
Press the GO key. The display will show: CONNECT PLUG TA301 TO CX304.
Plug the TA301 plug into the CX304-P1 connector.
Step 3.
Press the GO key.
The words TEST IN PROGRESS PLEASE WAIT will appear
on the display.
Step 4.
Wait for the display to change. If the self-test does not detect any
problems, the display will change to read REMOVE PLUG TA301 FROM CX304. When this
is the case, remove plug TA301 from cable CX304 and continue with the self-test.
If the display reads REMOVE CX304 FROM CIB J1, there is a problem in the system.
When this message is received, perform the following steps to isolate the defective
component:
(a)
Press the GO key.
The display should read REMOVE CX304 FROM CIB J1.
Unplug the CX304-P2 connector from the J1 connector on the CIB.
118
Previous Page
