Figure 16.
c. Install socket-head bolts which retain antidrive end housing to the
stator and intermediate housing.
d. Install brushes in brush holder and install brush holder with the two
screws that were originally removed.
e. Install new bearing in drive end housing and install voltage regulator
with four socket-head screws.
f.
Install spacer or seals on rotor shaft in reverse order of removal.
g.
Press regulator and housing on rotor shaft.
Caution:
The six-prong plug on the regulator must line up with its mate in the
alternator. Use the guide pin to properly pilot the housing while
pressing it on. Be sure the rubber "O" ring is in place on the drive
end housing (fig 17).
h.
Replace the six socket-head screws which retain the drive end housing.
i.
Install key and fan using socket-head screw and retaining washer.
j. Install the pulley spacer, woodruff key, and pulley. Install the guard
washer and pulley nut, torquing to 50 ft-lb. When possible, use a new pulley nut
as its self-locking ability is reduced after the nut has been removed.
OS 010, 2-P13
Previous Page
