• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Figure 15. Checking the Status Indicator and Gun Reticle.
Boresighting the 7.62mm Coaxial Machinegun.
Figure 16. Installing The Boresight Adapter And Telescope in The Machinegun Barrel.

The M2/m3 Bradley Fighting Vehicle: Fire Control System
Page Navigation
  14    15    16    17    18  19  20    21    22    23    24  

M2/M3 BFV: FIRE CONTROL SYSTEM - OD1608 - LESSON 1/TASK 2
(2) Check to be sure that 7.62 appears in the status indicator
(figure  15).
If  it  does  not  appear  in  the  status  indicator,
troubleshooting
must
be
performed
to
isolate
the
problem.
Troubleshooting  procedures  can  be  found  in  TM  9-2350-252-20-2-1,
chapter 3.  If 7.62 does appear in the status indicator, boresighting
can continue.
FIGURE 15.
CHECKING THE STATUS INDICATOR AND GUN RETICLE.
(3) Check the alignment of the gun reticle (figure 15) on the
aiming point of the target.
It should be aligned.
If it is not
aligned on the aiming point of the target, troubleshooting must be
performed  to  isolate  and  correct  the  problem.
Troubleshooting
procedures  can  be  found,  when  needed,  in  TM  9-2350-252-20-2-1,
chapter 3.  If the reticle is aligned, boresighting can continue.
(4) It will now be necessary for the helper to move to the
commander's seat.  Since the coaxial machinegun is boresighted on the
same target as the 25mm gun, be careful not to move the handwheels or
controls while moving to the commander's station.
19






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.