• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Replace Steering Shaft Assembly.
Figure 13. Removing Bell Crank And Plate.
Figure 15. Removing Hull Access Cover.

M2/M/3 Bradley Fighting Vehicle Steering System
Page Navigation
  18    19    20    21    22  23  24    25    26    27    28  

M2/M3 BFV:
STEERING SYSTEM - OD1605 - LESSON 1/TASK 1
FIGURE 14.
ADJUSTING AND INSTALLING
CONNECTING LINK.
Step 9.  Close and secure the power unit access door and then raise
and secure the trim vane.
Step 10.
The vehicle should be driven to check operation of the
steering  system.
The  vehicle  should  not  veer  when  the  yoke  is
centered.
c.
Replace Steering Shaft Assembly.
This maintenance task will
cover the removal and installation of the steering shaft assembly.
(1) Initial Setup.
(a) Tools.  General mechanic's tool kit:
automotive, 1/2 inch
drive, 0 - 175 ft-lb torque wrench.
(b) Materials/Parts.  Three self-locking nuts, two lockwashers,
and steering shaft assembly.
(c) Personnel
Required.
Bradley
fighting
vehicle
systems
mechanic.
(d) Equipment Conditions.
Engine is stopped.
23






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.