MAINTENANCE OF THE M88A1 - OD1672 - LESSON 3/TASK 2
FIGURE 45. REPLACING THE VENTILATOR
BLOWER SWITCH (CONTINUED).
(2) Installation of VENT BLOWER Switch.
This subparagraph describes the
installation of the new VENT BLOWER switch.
Step 1.
Procure a new VENT BLOWER switch and connect the two electrical
cables (figure 45, view D) to the switch.
Step 2. Install the two screws and washers (figure 45, view C) securing the
VENT BLOWER switch onto the accessories panel.
Step 3. Position the accessories panel on the vehicle mounting, and install
the four screws and washers (figure 44 on page 95) securing the panel onto
the vehicle mounting. This step completes the
96
Previous Page
