M2/M3 BFV: TROUBLESHOOTING - OD1610 - LESSON 1/TASK 1
(a) Item 1.
Item 1 is the name of the procedure.
(b) Item 2. Item 2 is the initial setup. This lists the tools,
materials/parts, personnel, references, and equipment conditions needed to
perform the procedure.
(c) Item 3.
Item 3 is the task steps.
These boxes give step-by-
step instructions.
(d) Item 4.
Item 4 contains the drawings used to help locate and
identify parts.
(e) Item 5. Item 5 is a question. This is the last step in most
procedures. The answer to this question will direct you to the next box.
(f) Item 6. Item 6 is the reference letter. This will send you
to the correct box to go on with the troubleshooting procedure.
(2) STE-M1/FVS (VTM Only) Test Procedure.
A STE-M1/FVS (VTM Only)
test procedure describes how to use the STE-M1/FVS (VTM Only).
These
procedures will be used to test electrical parts of the vehicle.
While
performing the troubleshooting procedure, you may be asked to go to a STE-
M1/FVS (VTM Only) test procedure. Figure 2 (on the following page) is an
illustration of the STE-M1/FVS (VTM only) test procedure. In the paragraphs
that follow, the main parts of this procedure will be discussed.
(a) Item 1.
Item 1 is the title.
This tells the name of the
procedure.
(b) Item 2. Item 2 is the initial setup. This lists the tools,
materials/parts, personnel, references, and equipment conditions needed to
perform the test procedure.
(c) Item 3.
Item 3 is the task steps.
These give step-by-step
instructions for performing the test.
(d) Item 4.
Item 4 contains the drawings.
These help to locate
and identify parts.
9
Previous Page
