M2/M3 BFV: FIRE CONTROL SYSTEM - OD1608 - LESSON 2/TASK 4
FIGURE 66.
CONNECTION 2W101P3/2A33J1.
Whenever a corrective action
has been taken in the test and
inspection procedure, test 2731
should be performed again to see if
the symptom has been corrected.
This should be continued until a NO
FAULTS FOUND condition exists.
When a NO FAULTS FOUND message is
displayed on the SETCOM during
a repeat test, and the symptom has
been corrected, perform the
follow on procedures described in
paragraph 2b(3) on page 102.
3.
Conclusion
Successfully performing tests 2733, 2730, and 2731 on the ISU using
the STE-M1/FVS test set will help to isolate faulty components and
ensure that the equipment is operating properly.
Components of the
fire control system which are well maintained help assure the safety
of the Bradley fighting vehicle crew.
105
Previous Page
