M2/M3 BFV: FIRE CONTROL SYSTEM - OD1608 - LESSON 2/TASK 4
(c) Check connections 2W103P4 to 2A1001J3, and 2W103P3 to
2A1001J2, and 2W101PI TO 2A1001JI (refer to figure 57 on page 90).
(d) Next, inspect connection 2W101P2 to 2A34J1 (figure 65).
FIGURE 65.
CONNECTION 2W101P2/2A34J1.
(e) Check
connection
2W101P3
to
2A33J1
(figure
66
on
the
following page).
(f) Inspect vehicle distribution box connections 2W101P4 to
2A1J5 and 2W5P5 to 2A1J14 (refer to figure 58 on page 90).
(g) Finally,
check
connection
2W5P2
at
2A5J1
at
the
TOW
control box.
(3) Repeating Test 2731. When all of the connections have been
checked and tightened, if needed, test 2731 should be repeated in
hopes of obtaining a NO FAULTS FOUND condition. Before repeating the
test, it may be necessary to connect some components disconnected
during testing (i.e., if disconnection was required by the SETCOM
instructions).
If required, install plug 2W201P1 on jack 2A1001J4,
install plug 2W201P2 on jack 2A1012J4, and install the cap on the
diagnostic panel jack J2.
104