M2/M3 BFV:
STEERING SYSTEM - OD1605 - LESSON 1/PE 1
3.
Requirement
Below is a list of questions that SSG Fields feels will give him a
general idea of how much the other mechanics know about steering
system troubleshooting and maintenance procedures. Provide an answer
sheet for the questions that follow.
a.
What is the first step that is performed when troubleshooting
the steering system?
b.
When the steering yoke does not return to the center, a check is
made for a faulty steering shaft. How is the check executed?
c.
The connecting links of the steering system are attached to what
component?
d.
What part on the vehicle is
removed
in
order
to
check
the
steering control lever for binding?
e.
The plate to which the bellcrank is attached to is located on
the _________________.
f.
What tool is always used to repair or replace components of the
steering system?
g.
What test equipment is used to run TEST NO. 10 ENGINE RPM (IDLE) ?
h.
Which technical manual contains the troubleshooting procedures
for the steering system?
i.
What function
must
be
performed
after
every
troubleshooting
procedure?
j.
What would a mechanic do with locknuts and cotterpins after they
are removed?
k.
On what component of the steering system is the link bearing
located?
l.
What jack of the steering yoke assembly is connected to switch
assembly plug P1?
m.
Before
beginning
any
maintenance
procedure,
the
correct
equipment condition for the vehicle is to ________________.
36
Previous Page
