e. Standard Initial Test Conditions (5). This block tells you to
locate and set all tank controls in the correct position prior to
starting the fault isolation process.
(This lesson describes the
standard initial test conditions in part B.)
f. Tools (6).
This heading gives the special, fabricated, or
common tools and any test equipment needed to perform the
troubleshooting procedure.
This heading, like the "Supplies"
heading, gives the location in the TM where you can find information
on the tools required (i.e., item 78, Appendix E).
Figure 1-2.
Sample Procedure (Part One).
NOTE:
The following call-out numbers refer to figure 1-3.
g. Connector Inspection Block (1).
This block gives a list of
the connectors and a connector location index reference (page number)
for the connectors that could cause the fault you must troubleshoot.
You must always check the connectors listed prior to using the STE
test set.
h. Go To Block (2). After answering a question, this block sends
you to another part of the fault isolation procedure to continue the
troubleshooting procedure.
7
OD1711
Previous Page
