90.
The Prestolite drive assembly is located at the armature
a.
commutator end.
b.
splined end.
c.
threaded sleeve end.
91.
What makes it possible to control the starter from an outside source?
a.
Solenoid relay
b.
Starter switch
c.
Voltage regulator
92.
During disassembly of the Prestolite starter, what is first to be removed?
a.
Solenoid assembly
b.
Pinion housing assembly
c.
Intermediate housing assembly
93.
In the Prestolite starter the shift lever yoke is held by the
a.
intermediate housing.
b.
solenoid housing.
c.
yoke cover.
94.
Before the yoke cover can be freed in the Prestolite starter, the
a.
drive assembly must be removed.
b.
intermediate housing must be removed.
c.
yoke pin must be tapped from the cover.
95.
Before the armature can be freed during disassembly of the Prestolite
starter, the
a.
commutator and head assembly must be removed.
b.
intermediate housing must be removed.
c.
brush holder assembly must be removed.
96.
The brushes of the Prestolite starter are cleaned
a.
with a dry cloth only.
b.
and soaked in drycleaning solvent.
c.
with a cloth dampened in drycleaning solvent.
97.
To inspect for armature grounds the continuity is checked between the armature
a.
commutator riser bars.
b.
core and rotor shaft.
c.
core and commutator riser bars.
98.
What is used to inspect the armature for shorts?
a.
Growler and steel strip
b.
Growler and continuity test leads
c.
Lathe and dial indicator
99.
What is used to inspect the commutator concentricity?
a.
Growler and steel strip
b.
Growler and continuity test leads
c.
Lathe and dial indicator
06 010, 6-P30
Previous Page
