BANDSAW OPERATIONS - OD1646 - LESSON 2/PE 2
PRACTICAL EXERCISE 2
1.
Instructions
Read the scenario and respond to the requirements that follow the scenario.
2.
Scenario
You are now fairly confident that the Saudi representative knows enough
about bandsaw operation.
However, you need to be sure that the bandsaw
machines can be maintained properly, and that the Saudi personnel can
perform troubleshooting on the machines, should problems arise.
3.
Many of the maintenance procedures for the various models of bandsaw
machines are similar, or the same for all models. Some procedures, however,
are specific to only one model. You have prepared an outline covering the
maintenance procedures which apply to the models of the bandsaw machine
available to the Saudis.
Each question below is based on that outline.
Answer each question correctly.
a.
What must be done if a wheel brush is worn so that it is not longer
contacting the wheel face?
b.
What type of lubricant should be used on the wheel bearings?
c.
What
could result
if
the
faces of
the
variable
speed
pulley
are
scored?
d.
How is the center sheave of the variable speed pulley lubricated?
e.
Briefly describe the procedure for replacing a wheel tire on the model
2612-1M bandsaw machine.
f.
What is used to lubricate the air pump on the model 1612-0 bandsaw
machine?
g.
Describe the position of the motor bracket on the model 1612-0 bandsaw
machine when the bracket is properly adjusted.
85
Previous Page
