Figure 69. Cylinder Sleeve Puller.

Use And Care Of Handtools And Measuring Tools
Page Navigation
92

A chain-type wheel puller is also available that has a 1 ton pulling

capacity (not illustrated).

(i) Cylinder Sleeve Puller. The universal cylinder sleeve puller

(figure 69) will pull the cylinder sleeves on more than 200 makes and models

of trucks and tractors. It is adjustable to provide clearance regardless of

the position of the cylinder studs and to simplify centering the tool over

the bore.

This puller is used in conjunction with four adapter plates

supplied with the puller.

The combination is capable of pulling cylinder

sleeves 4 1/4, 4 1/2, 4 3/4, and 5 3/4 inches in diameter.

(j) Slide Hammer Puller. The slide hammer puller set (figure 70

on the following page) is a universal-type puller equipped with a two- and

three-way yoke and three medium jaws for outside pulls, and two small jaws

for inside pulling.

The small jaws can be inserted through a 1/2 inch

opening. The capacity of the medium jaws is 6 1/4 inches. The slide hammer

puller is also equipped with a locking feature which holds the jaws open or

locks them on the work.

FIGURE 69.

CYLINDER SLEEVE PULLER.