39.
What are the positions of the relay lamp switch?
a.
ON-OFF
b.
6V-12V-24V
c.
12V-OFF-24V
40.
The MANUAL position of the field circuit switch is used when
a.
testing a generator with no regulator in the circuit.
b. making an alternator rectifier short circuit check.
c. adjusting the starter torque field winding phase screw.
41.
Which unit is being tested when the headset phone Jack and pile flutter
a.
Starter
b.
c.
Regulator
42.
The coil equalizer switch is an OFF-MOMENTARY-ON toggle switch located below
a.
b.
c.
adjusting AC/DC system phase.
43.
Which action occurs when the drive speed control is rotated counter-clockwise?
a.
Lower varidisc hub slides away from its companion varidisc
b.
V-belt assumes a larger diameter on upper and lower varidiscs
c.
Moveable varidisc on drive shaft retracts against spring
44.
Where on the electrical wiring diagram are the tachometer, generator,
and
associated circuits located?
a.
Center section
b.
Left of center
c.
Right of center
45.
Controls must be in specific positions prior to operating the test stand.
Which control is set to the correct preoperational position?
a.
DC ammeter load and starter selector....................50A
b.
DC ammeter field and battery charger selector...........150A
c.
Millivolt meter range selector..........................9V
OS 010, 3-P34