129.
How is the vacuum pump of the distributor tester lubricated?
a.
Through a Zerk fitting accessible from back of stand
b.
Through the vacuum hose with pump running
c.
Through oil filler pipe at side of test stand
130.
What is a purpose of the circuit analyzer accessory of the heater test stand?
a.
To check the electrical circuits of the heater test stand
b.
To check the vehicle's heater electrical system with the heater removed
c.
To check heater electrical circuits with the heater installed in the
vehicle or on the test stand
131.
What type of indication does the operator observe when using the circuit
analyzer?
a.
Light
b.
c.
132.
Which power source can be used to operate the heater test stand?
a.
24VDC
b.
120 volts, 400 Hz, single phase
c.
220 volts, 60 Hz, three phase
133.
How many functions can be selected by the TS-352 B/U multimeter function
selector switch?
a.
2
b.
4
c.
6
134.
Which batteries need replacing when the TS 352- B/U multimeter cannot be zero
adjusted on the RX 10,000 range?
a.
1.5v
b.
4.5v
c.
6v
135.
How many independent circuits are there in the low voltage circuit tester?
a.
2
b.
3
c.
4
OS 010, 8-P31
Previous Page
