EXERCISE
Note. -
Refer to exercise instructions listed in lesson 1.
121.
Which armature test set circuit consists of a primary coil and a portion of
the iron of a transformer?
a.
Growler
b.
c.
Test lamp
122.
Who checks for possible MWO's applicable to the armature test set?
a.
Operator/crew personnel
b.
Organizational personnel
c.
Administrative personnel
123.
Which type of check is normally used when troubleshooting the ignition timing
light?
a.
Voltage
b.
Amperage
c.
124.
The battery of the magneto timing light should be replaced when a periodic
check indicates its potential is less than
a.
3.9 volts.
b.
5.9 volts.
c.
11.9 volts.
125.
When troubleshooting the magneto timing light, the battery, switch, and
transformer primaries are found to be OK. Which item should be checked next?
a.
Vibrator
b.
Capacitor
c.
Glow lamp
126.
What speed (RPM) should be indicated when making a top speed check on the
magneto test stand?
a.
120
b.
440
c.
4,200
127.
When should the operator check the distributor tester switches for positive
action?
a.
Before operation
b.
During operation
c.
After operation
128.
Which malfunction of the distributor tester may be corrected by the operator?
a.
Work lamp fails to light
b.
Tester chatters or vibrates under speed
c.
Electrical cable nipples do not insulate electrical clips properly
0S 010, 8-P30
Previous Page
