• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Corner Joint
Welding Joint Design
Figure 6. Corner, Edge, Lap , and Tee Joints.

Welding Operations, I
Page Navigation
  16    17    18    19    20  21  22    23    24    25    26  

WELDING OPERATIONS I - OD1651 - LESSON 1/TASK 1
FIGURE 5.
BUTT JOINTS.
(2) Corner Joint (figure 6, views A through D, on the following
page).
This type joint is used to join two members located
approximately at right angles to each other in the form of an L.
The fillet weld corner joint, shown in figure 6, view A, is used
in the construction of boxes, box frames, tank containers and
similar fabrications.
The closed corner joint, shown in figure
6, view B, is used on lighter sheets when high strength is not
required at the joint.
When using oxyacetylene welding, the
overlapping edge is melted down and
20






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.