• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Ending the Self-test - Od160870092
Checking CIB Cable CX305. - Od160870091
Conclusion - Od160870093

The M2/m3 Bradley Fighting Vehicle: Fire Control System
Page Navigation
  79    80    81    82    83  84  85    86    87    88    89  

M2/M3 BFV: FIRE CONTROL SYSTEM - OD1608 - LESSON 2/TASK 1
3 Wait for the display to change.  If the new message on
the display reads FAULTY CX305, replace cable CX305 and repeat the
self-test.
If the new message FAULTY CIB appears, replace the CIB,
in  accordance  with  the  instructions  found  in  TM  9-4910-751-14-1.
Then repeat the self-test.
(7) Ending the Self-test.  Once it has been determined that all
of the STE test set components are operating properly, the self-test
is ready to be completed.
To finish the self-test, follow these
steps:
(a) Press the GO key.
The message TEST FINISHED PUSH STOP
AND CLEAR will appear on the display.
(b) Press  the  STOP  key;  then  press  the  CLEAR  key.
The
message ENTER TEST NUMBER will appear on the display.  At this point,
the test set is ready to perform tests on the vehicle.
Specific
instructions for using the STE-M1/FVS test set to perform three tests
on the Bradley fighting vehicle fire control system will be found in
the next three tasks of this subcourse.
6.
SETCOM Messages
When  using  the  STE  in  testing  and  troubleshooting,  a  number  of
messages could appear on the SETCOM unit.
Often, these messages
refer to indexes in one or more technical manuals.
Two of these
indexes are described here:
a. Message  Word  Index.
The  message  word  index  directs  the
mechanic to a message word.
The index contains the number of the
message word which should match the number appearing on the SETCOM
during testing.  It also contains the name of the part to which the
message word number refers and the page number where the message word
can be found.
(1) Message Words.  A message word is a drawing of a part of a
system.  The drawing is used to find a part needed to test to find a
fault.
The SETCOM tells how to test the parts seen in the message
word.  The message word drawings show the number of the message word,
the message word item name, the
84






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.