M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 3/TASK 2
replace the wiring harness, following the procedures in TM 9-2350-252-20-2-2, page
5-305.
(c)
If no faults are found in wiring harness 2W202 during tests 2390 and
2391, the problem could be a loose connection.
Therefore, the next step is to
check various connections for tightness.
(2)
Testing Connections for Tightness.
If the problem showing up in the
turret drive power is not being caused by a faulty wiring harness 2W202, traverse
the turret to 3200 mils (TM 9-2350-252-10-2), move the TURRET POWER switch to OFF
and move the MASTER POWER switch to OFF. The following cable connections should be
checked to isolate the problem:
(a)
Check the connection of cable 2W302P7 to 2A200J2 (figure 24).
If either
connection is not tight, tighten it.
FIGURE 24.
CONNECTION 2W302P7/2A200J2.
127
Previous Page
