• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Figure 36. Milling Operations On the Lathe
Mounting of the Versa-Mil.
Mounting on a Lathe.

Lathe Operations
Page Navigation
  84    85    86    87    88  89  90    91    92    93    94  

LATHE OPERATIONS - OD1645 - LESSON 1/TASK 2
FIGURE 36.
MILLING OPERATIONS ON THE LATHE.
NOTE
Unless  both  versa-mil  and  the  work  are  rigidly
supported,  it  is  difficult  to  obtain  accurate,
chatter-free results.
(c) The bases of the basic unit are provided with two sets of mounting
holes.  Two cap screws in the opposite holes are used to attach the base.
The alternate holes permit a 90 change in position.  Before tightening the
cap screws, the circular face plate should be square with the work or the
work table surface.
(d) An adapter plate may be necessary for mounting on some machine tools
where the center distance of the base plate holes does not conform
89






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.