• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Unload/Stow 25mm HE Ammo.
Figure 8. Unload 25 mm gun Feeder.
Procedural Steps for Unloading/Stowing 25mm HE Ammo.

M2/M3 Bradley Fighting Vehicle: Turret
Page Navigation
  50    51    52    53    54  55  56    57    58    59    60  

M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 1/TASK 2
NOTE
If the handcrank assembly was used in step 17, continue to
turn the handcrank assembly until the round drops into the
helper's hand.
Step 19.
Continue to turn the wormshaft nut until the round drops into the
helper's hand.
Step 20.
Time 25mm gun feeder.
These procedures, when needed, can be found on
page 2-240 in TM 9-2350-252-10-2.
Step 21.
Remove ammo from face of bolt.
Step 22.
Check the chamber for ammo.
If ammo is found in the chamber, remove
ammo.
Step 23.
Check the forward eject port for ammo.
If ammo is found in the forward
eject port, remove ammo.
e.
Unload/Stow 25mm HE Ammo.
These subparagraphs will cover the unloading and
stowing of the 25mm HE ammo.
(1)
Initial Setup.
(a)
Tools: 14mm ratchet wrench.
(b)
Personnel Required: Gunner and helper.
(c)
References: TM 9-2350-252-10-1 and TM 9-2350-252-10-2.
(d)
Equipment Conditions.
Vehicle parked and MASTER POWER switch ON.
(2)
Procedural Steps for Unloading/Stowing 25mm HE Ammo.
Step 1.
Remove the HE link eject chute from the 25mm gun feeder.
Step 2.
Unload the HE ammo from the 25mm gun feeder.
Step 3.
Traverse turret to the HE load position (2150 mils).
These procedures,
when needed, can be found on page 2-152 of TM 9-2350-252-10-2.
55






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.