• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Procedural Steps for Unloading/Stowing 25mm AP Ammo.
Unload/Stow 25mm AP Ammo.
Figure 10. Unload/ Stow 25mm AP Ammo.

M2/M3 Bradley Fighting Vehicle: Turret
Page Navigation
  55    56    57    58    59  60  61    62    63    64    65  

M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 1/TASK 2
(a)
Tools: 14mm ratchet wrench.
(b)
Personnel Required: Gunner and helper.
(c)
References: TM 9-2350-252-10-1 and TM 9-2350-252-10-2.
(d)
Equipment Conditions: Vehicle parked and MASTER POWER switch ON.
(2)
Procedural Steps for Unloading/Stowing 25mm AP Ammo.
Step 1.
Remove the AP link eject chute from the 25mm gun feeder.
Step 2.
Unload the AP ammo from the 25mm gun feeder.
Step 3.
Traverse turret to the AP load position (2150 mils).
These procedures,
when needed, can be found on page 2-152 of TM 9-2350-252-10-2.
Step 4.
Set the turret travel lock.
These procedures, when needed, can be
found on page 2-141 of TM 9-2350-252-10-2.
Step 5.
Move the TURRET DRIVE SYSTEM switch to OFF.
Step 6.
Move the TURRET POWER switch to OFF.
Step 7.
Open the turret shield door.
These procedures, when needed, can be
found on page 2-139 of TM 9-2350-252-10-2.
Step 8.
Remove the AP ammo can door by turning the handle to the right.
Then
remove the AP ammo can door from the AP ammo can.
WARNING
A  cartridge  explosion
could  kill  or  injure  soldiers.
Handle ammo with care.
Do not bump primers against any
hard surface.
Step 9.
Unload the AP ammo from the AP feed chute by placing a 14mm ratchet
wrench on the shaft of the AP forwarder, with the wrench handle to the
60






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.