• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Procedural  Steps  for  Installation  of  the  Encoder  and  Slipring  Assembly.
Removal of the Encoder and Slipring Assembly. - Continued
Installation of the Encoder and Slipring Assembly.

M2/M3 Bradley Fighting Vehicle: Turret
Page Navigation
  86    87    88    89    90  91  92    93    94    95    96  

M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 2/TASK 3
Step 12.
Remove three screws, lockwashers, and washers attaching the adapter to
the slipring.  Then remove the adapter from the slipring.  Discard the lockwashers.
c.
Procedural  Steps  for  Installation  of  the  Encoder  and  Slipring  Assembly.
Three final procedures are needed to complete the installation of the encoder and
slipring assembly.
These procedures are described in subparagraphs 2c(2) through
2c(4) below.
(1)
Installation of the Encoder and Slipring Assembly.
Step 1.
Install adapter, three washers, new lockwashers, and screws on the
slipring.
Step 2.
Install the coupling on the encoder shaft with a setscrew aligned with
the flat surface on the encoder shaft.  Adjust the coupling onto the encoder shaft
so that .138 to .198 inch is between the coupling and the encoder.
Tighten two
setscrews on the top half of the coupling.
NOTE
The setscrew aligned with the flat surface on the encoder
shaft  is  the  same  setscrew  that  is  aligned  with  flat
surface of the slipring shaft.
Step 3.
Set the encoder to mechanical zero setting by turning the adapter until
the flat surface of the slipring shaft can be seen in the nipple hole of the
adapter.  Align the setscrew on the coupling with the flat surface of the slipring
shaft, then place the encoder on the adapter.
NOTE
Slipring, adapter, and encoder shaft must stay in the same
position set in step 3 or mechanical zero will be lost.
Step 4.
Locate two setscrews on the coupling through the plug hole on the
adapter.
Tighten a setscrew.  Rotate the adapter slowly until the
91






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.