• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Running Test 2730.
Preparing for Test 2730
Test  Continuation - Od160870104

The M2/m3 Bradley Fighting Vehicle: Fire Control System
Page Navigation
  90    91    92    93    94  95  96    97    98    99    100  

M2/M3 BFV: FIRE CONTROL SYSTEM - OD1608 - LESSON 2/TASK 3
(4) If no faults are found during the STE self-test, remove the
center turret floor plate (TM 9-2350-252-20-2-2, page 4-22).
b. Running Test 2730.  To run test 2730, enter 2730 on the SETCOM
and wait for the SETCOM response.
(1) If the SETCOM displays a cable instruction message word
number, refer to the message word number index found on page 3-553 of
TM 9-2350-252-20-2-1 and follow the SETCOM instructions.
Assume,
however, for the purposes of this subcourse, that the SETCOM does not
display a cable instruction message word number.
(2) If  the  SETCOM  displays  a  fault  message,  it  would  be
necessary to refer to the fault number index found on page 3-605 of
TM 9-2350-252-20-2-1.  However, assume again that no fault message is
displayed.
(3) The third possibility is that the display will show a NO
FAULTS FOUND message.  When this is the case, the same two questions
apply as were asked before continuing the procedure in test 2733, Is
the test being repeated? Has the symptom been corrected?  If the test
is  being  run  for  the  first  time  and  the  symptom  has  not  been
corrected, further testing is required as described in paragraph 2c
on the following page.  If the test is being repeated, or if the test
is not being repeated but the fault symptom that prompted the test
has been corrected, the test is essentially complete.  In this case,
the follow-on procedures listed below should be performed.
(a) If  the  test  is  a  repeat  or  the
symptom
has
been
corrected, move the TURRET POWER switch to OFF.
(b) Turn OFF the MASTER POWER switch.
(c) Remove the STE test set from the vehicle distribution
box.
(d) If  they  were  removed  during  earlier  test  procedures,
install the center and right turret floor plates (TM 9-2350-252-20-2-
2, page 4-22).
95






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.