• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Glow Plug System.
Figure 6. Windshield Wiper/Washer System Schematic
Glow Plug System. - Continued

Troubleshoot The High Mobility Multi- Purpose Wheeled Vehicle (HMMWV)
Page Navigation
  52    53    54    55    56  57  58    59    60    61    62  

TROUBLESHOOTING THE HMMWV - OD1616 - LESSON 1/TASK 2
Step 4.  Disconnect lead 71C from the wiper motor.  With the rotary
switch in the RUN position and the washer switch depressed, check for
battery  voltage  on  lead  71  at  the  wiper  motor.
If  voltage  is
present, repair the body wiring harness following the procedures in
paragraph 4-62, page 4-110 of the TM.  If the wiring harness cannot
be repaired, notify IDS/IGS maintenance.
Step 5.  Check for continuity from terminal 27 to terminal 71 on the
wiper motor with the washer switch depressed.
If no continuity is
present,  replace  the  wiper  motor  following  the  procedures  in
paragraph 10-47, page 10-70 of the TM.
g.
Glow  Plug  System.
While  reading  through  these  paragraphs
concerning  troubleshooting  malfunctions  in  this  system,  refer  to
figure 7.
Troubleshooting the Malfunction:
GLOW PLUG SYSTEM CONTINUES TO CYCLE
AFTER ENGINE IS WARMED UP.
FIGURE 7.
GLOW PLUG SYSTEM SCHEMATIC.
56






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.