• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print

Home > Ordnance Documents and other related manuals > > Figure 24. The VTM
Figure 22. VTM Jack J1
Hook Up to DCA 13

The M2/M3 Bradley Fighting Vehicle: Fire Suppression System
Page Navigation
  28    29    30    31    32  33  34    35    36    37    38  

M2/M3 BFV: FIRE SUPPRESSION SYST - OD1607 - LESSON 2/TASK 1
(3) Install  plug  W1P2  on  the  vehicle  distribution  box  jack
1A1J14 (DCA 3)(figure 23).
To do this, remove the cap from jack
1A1J14 (DCA 3) and install plug W1P2 on the jack.
(4) Move the MASTER POWER switch to the ON position.
(5) Push the VTM circuit breaker (figure 24) to ON.
Three
situations could arise.
If all is working well, the display should
read 8.8.8.8 and then - - - - (four dashes).  If the display does not
read 8.8.8.8.
and - - - - (four dashes) consecutively, but is not
blank, the VTM is faulty and should be written up as such on DA Form
2404.
If  the  display  is  blank,  the  procedures  for  performing
diagnostic troubleshooting of the STE-M1/FVS (VTM only) for a blank
display can be found, when needed, on page 3-903 of TM 9-2350-252-20-
1-1.  These procedures will not be covered in this subcourse.
(6) If the display reads correctly, perform the VTM confidence
check using the instructions on the flip cards on the VTM.
If the
VTM  confidence  check  does  not  pass,  the  VTM  confidence  test
diagnostic troubleshooting procedures can be found, when needed, on
page 3-910 of TM 9-2350-252-20-1-1.
These procedures will not be
covered in this subcourse.
FIGURE 24.
THE VTM.
33






Western Governors University

< Previous Page
Index ^
Next Page >

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.