Lesson 3/Learning Event 4
A wrong VID number was entered. The VTM will only accept numbers
between 01 and 28. If E010 is displayed when the VID entered was between
01 and 28, it means that the VID does not agree with the identity of DCA
harness powering the VTM. Testing may continue.
Throttle control was operated incorrectly. It took too long to accelerate or
decelerate during power test.
The SI ignition adapter, TK item 30, or CI pulse tachometer, TK item 34, is
missing or not connected to the VTM.
VTM unable to use data received.
The wrong number of cylinders was entered.
The number-of-cylinders information entered does not agree with the
number of cylinders in the vehicle powering VTM (DCA harness).
VTM not receiving ignition information.
Test discontinued due to no information being detected by VTM. This will
occur after several minutes of no-signal operation.